Search
Generic filters
Exact matches only

Gated Integrating Amplifier – GIA100

You are here:
Estimated reading time: < 1 min

FAQ

Can I use the GIA100 for averaging several pulses?

Yes. The GIA100 is fully controlled by two hardware control lines on the interface. One control line puts the amplifier in sampling or in hold mode. The other line resets the output signal. Averaging is performed by sampling the given number of pulses without resetting in between each pulse. In this case, the gain must be selected such that the sum of the pulses does not exceed the maximum output voltage of the amplifier.

Was this article helpful?
Dislike 0
Views: 111

Hannes Heppner

OptiCS

Dr. Steven Wright

CUSTOMIZED SOLUTIONS

Dr. Steven Wright

CUSTOMIZED SOLUTIONS

Hannes Heppner

OptiCS

Anja Weets

OPTICS

Rolf Jaspers

Instruments